Topic: Streamline Engine Tools - Loop Cut then Slide - July 28  (Read 36 times)

0 Members and 1 Guest are viewing this topic.

  • Posts: 449
  • Triangle
August 05, 2018, 02:09:23 AM
I'm having a issue with this tool

I click where I want the cut to be made. That part is all fine.

If I continue to hold the LMB down and slide it too close to another edge it merges with the edge (either partly or entirely) and does not unstick. I always have to undo and try again.

  • No avatar
  • Posts: 2093
  • Polygon
August 11, 2018, 10:23:17 AM
Hi Kevyon,

The only thing I can currently think of, is that you may of set "Modeling Options > Auto Weld Enabled".

  • Posts: 449
  • Triangle
August 11, 2018, 08:01:15 PM

Thanks for that, it took a bit of searching through the menus to find it but yep you were right, turning off autoweld solved it.

Back in business now !