Topic: Retopo Mode Collapse  (Read 242 times)

0 Members and 1 Guest are viewing this topic.

  • Posts: 194
  • Spline
December 28, 2017, 09:04:02 PM
During retopology process i noticed that if i enable Retopo mode and cut my retopo mesh the new vertexes respecting retopo mode and automatically snapping to the reference mesh.

But if i select some edges and use "Subobject Shortcut Tools>> Collapse" the new collapsed edges does not snap the the reference mesh automaticaly. In the moment i need to select this edges and move a little so they snaps right.

Is it possible to add this "auto" snapp behavior to the "Subobject Shortcut Tools>> Collapse" function?
And to the "Generic Tools >> Relax" function.

Thanks in advance.
« Last Edit: December 28, 2017, 09:22:15 PM by Woolfy »

  • Posts: 904
  • Polygon
December 28, 2017, 11:29:02 PM
Until it's fixed, instead of moving new vertices in order to snap them, you can use Subobject Shortcut Tools->Reference Snap_Projection or Subobject Shortcut Tools->Reference Snap_Normal.

  • No avatar
  • Posts: 3335
  • Developer
  • Administrator
  • Polygon

  • Posts: 194
  • Spline
January 08, 2018, 01:43:43 PM
Thanks a lot Istonia and Rubber Duck!!! "Subobject Shortcut Tools>> Collapse" Works amazing!!
« Last Edit: January 08, 2018, 01:50:57 PM by Woolfy »